[Public-List] Mast Sheave Washers

[Mike Lehman]

Unless you are running all rope halyard, 3/8" line does not seem to have 
enough space to jump the sheave.



Mike Lehman

><((((º>`·.¸¸.·´¯`·.¸><((((º>`·.¸¸.·´¯`·.¸><((((º>
-----Original Message----- 
From: Michael Grosh
Sent: Thursday, July 26, 2012 10:04 PM
To: Alberg 30 Public List -- open to all
Subject: Re: [Public-List] Mast Sheave Washers

You don't want any space at all between the sheave and the plates. Give the
wire halyard an opportunity to jump out, and it will take it. I have a
machine bolt tapped into the side of the mast to adjust the squeeze. It
(the sheave) needs to be snug.

MichaelGrosh
#220
On Jul 26, 2012 9:23 PM, "John Mcauliffe" <jmcsales at gmail.com> wrote:

> Have a question on the placement of the 2 Brass Washers - do they go
> between the sheave and plates?
> When I took it apart they were siliconed to the outer sides of the plates.
> Just didn't seem right. Any advice?
>
> Sent from my iPhone
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>
_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org 


 1343389923.0