[alberg30] Re: (no subject)

[Gordon E. White]

From: "Gordon E. White" <gewhite at crosslink.net>

    Anyone needing to pull his prop:  I did that this afternoon and the
nut on my shaft is a 1 1/16" hex. Needs a deep socket and of course I
had 1" and 1 1/8 " deep sockets. Fortunately I had a 1 1/16 open end
wrench, though I prefer to use a socket.

    It took about 10 minutes of heat from a  little propane torch
before the prop would come free - I did not want to bang on the prop too
hard and it is difficult to get a puller on a 3-blade prop inside the
aperature in the rudder.


Gordon White A-275


------------------------------------------------------------------------
To unsubscribe from this mailing list, or to change your subscription
to digest, go to the ONElist web site, at http://www.onelist.com and
select the User Center link from the menu bar on the left.

 916589382.0