[Alberg30] Beck Beam Details

[sousa, stephen (ENG)]

Richard,

There is a molding (correct me if I am wrong) that sits above the doors. I
needed to sand that down for a flush fit with the plates against the beam. I
can measure the bolts that I used to hold the plates in place, and send a
note this evening. 

Stephen 

-----Original Message-----
From: Hansen, Richard D LTC Student
[mailto:Richard.Hansen at carlisle.army.mil] 
Sent: Wednesday, April 30, 2003 11:22 AM
To: 'Alberg 30 public list'
Subject: RE: [Alberg30] Beck Beam Details


Deck Beam article suggests purchasing 1/4 Stainless Steel Bolts to secure
plates to beam.  Two questions: 1. What length of bolts...6 inches? 2. Where
can one buy them (Lowes and H-Depot sell only galvanized)? Thanks

-----Original Message-----
From: Mike Lehman [mailto:sail_505 at hotmail.com]
Sent: Friday, April 04, 2003 8:51 PM
To: Alberg 30 public list
Subject: Re: [Alberg30] Beck Beam Details


You should jack it up until the curve profile of the existing beam matches
that of the aluminum reinforcement plates. I am having a hard time
understanding what the piece of wood is/does that you describe. Sounds like
something that was added and will need to be removed before the plates can
be installed.


----- Original Message -----
From: "Hansen, Richard D LTC Student" <Richard.Hansen at carlisle.army.mil>
To: "'Alberg 30 public list'" <public-list at alberg30.org>
Sent: Friday, April 04, 2003 1:46 PM
Subject: [Alberg30] Beck Beam Details


> -Sunspur is on the hard with mast removed.
>
> -Mast removal seems to have allowed the deck beam to return to a 
> position
to
> where the forepeak/closet door now closes without any binding.
>
> -My alum brackets need some minor mods at corners, but appear to fit
against
> beam ok.
>
> -There is, however, a 16 inch or so 3/4 inch piece of wood (teak?) in 
> the fore peak side of doorway.  It is flush with beam at center, but 
> about 1/4-3/8 inch below beam on both ends of piece.  Separation of 
> beam from glass is evident when looking at this 16" piece of wood. 
> Here are the questions: 1. Can I go ahead and install deck beam plates 
> or would you recommemd that
I
> still jack up deck a bit?
> Thank you.  
> +---------------------------------------------------------------+
>  |                This Old Boat by Don Casey                     |
>  | http://www.amazon.com/exec/obidos/ASIN/0071579931/alberg30-20 |  
> +---------------------------------------------------------------+
>
> Public-list mailing list -- Public-list at alberg30.org 
> http://www.alberg30.org/mailman/listinfo/public-list
> To unsubscribe: email to Public-list-request at alberg30.org Include 
> command "unsubscribe <password>" in subject or body. Use command 
> "help" for more options.
>
 +---------------------------------------------------------------+
 |                This Old Boat by Don Casey                     |
 | http://www.amazon.com/exec/obidos/ASIN/0071579931/alberg30-20 |
+---------------------------------------------------------------+

Public-list mailing list -- Public-list at alberg30.org
http://www.alberg30.org/mailman/listinfo/public-list
To unsubscribe: email to Public-list-request at alberg30.org Include command
"unsubscribe <password>" in subject or body. Use command "help" for more
options.  +---------------------------------------------------------------+
 |                This Old Boat by Don Casey                     |
 | http://www.amazon.com/exec/obidos/ASIN/0071579931/alberg30-20 |
+---------------------------------------------------------------+

Public-list mailing list -- Public-list at alberg30.org
http://www.alberg30.org/mailman/listinfo/public-list
To unsubscribe: email to Public-list-request at alberg30.org Include command
"unsubscribe <password>" in subject or body. Use command "help" for more
options.
 +---------------------------------------------------------------+
 |                This Old Boat by Don Casey                     |
 | http://www.amazon.com/exec/obidos/ASIN/0071579931/alberg30-20 |
 +---------------------------------------------------------------+

Public-list mailing list -- Public-list at alberg30.org
http://www.alberg30.org/mailman/listinfo/public-list
To unsubscribe: email to Public-list-request at alberg30.org
Include command "unsubscribe <password>" in subject or body.
Use command "help" for more options.

 1051727971.0