[Alberg30] hull and deck joint

[Alan Slater]

Roger,
Yes and also;
A machine screw generally has a screw head - flat, ovat, round, hexagon, etc. with a slot , philips, robinson, etc. drive.They are theaded full length, and  the diameter ranges between #0 through 3/4".
A bolt generally has a hex or square head for holding while the nut is torqued or it might have a head that is prevented from being turned as in a round head, track bolt or plow bolt. A bolt is not necessary threaded full length, and the diameter ranges from 3/8" and up.
I'm sure there is more to it than ths, but then there also a "cap screw"

Alan

p.s. I think a "machiene bolt" is a French version of above.
 +---------------------------------------------------------------+
 |                This Old Boat by Don Casey                     |
 | http://www.amazon.com/exec/obidos/ASIN/0071579931/alberg30-20 |
 +---------------------------------------------------------------+

Public-list mailing list -- Public-list at alberg30.org
http://www.alberg30.org/mailman/listinfo/public-list
To unsubscribe: email to Public-list-request at alberg30.org
Include command "unsubscribe <password>" in subject or body.
Use command "help" for more options.

 1066838880.0