[Public-list] Boot Stripe Height

[Roger L Kingsland]

Stephen,

I was planning on painting before the weather turns cold (sometime in
October) but I won't  launch until next spring.  I could just paint blue
down to the bottom paint and add the white stripe later.

Roger

Roger Kingsland
Managing Partner
KSBA Architects
N40°- 27.83'  W79°- 57.99'

(412) 252-1500 x101 office
(412) 779-5101 cell
----- Original Message ----- 
From: "sousa, stephen (ENG)" <sousa_stephen at emc.com>
To: "'Alberg 30 Public List -- open to all'" <public-list at alberg30.org>
Sent: Wednesday, August 03, 2005 9:00 PM
Subject: RE: [Public-list] Boot Stripe Height


> Roger,
>
> When do you need this information? The boot stripe on 114 is above the
> water, loaded with water, fuel and provisions. Empty she is above the
water
> by 3 inches.
>
> Stephen
>
> -----Original Message-----
> From: public-list-bounces at alberg30.org
> [mailto:public-list-bounces at alberg30.org] On Behalf Of Roger L Kingsland
> Sent: Tuesday, August 02, 2005 10:34 AM
> To: Alberg 30 Public List -- open to all
> Subject: [Public-list] Boot Stripe Height
>
> Stephen,
>
> A question RE the boot stripe.  I found the original boot stripe lines
> scribed in the hull which are definitely lower than the one I removed.
The
> section at the stern is about 10" wide.  Because I want to emphasize
> freeboard height (to me, the after cabin height relative to the freeboard
> amidships is a little tall) I would like to locate the new boot stripe as
> low as possible but, is sounds like it will be underwater if I use the
> original location.  Dose anyone know how much higher I need to place it so
> the entire stripe is out of the water when the boat is "at rest?"  I know
it
> depends on how much junk is on board but I abandoned plans for the onboard
> Jacuzzi so I think she will be loaded only slightly more than one of those
> hot shot racing boats.
>
> Roger
>
>
> Roger Kingsland
> Managing Partner
> KSBA Architects
> N40°- 27.83'  W79°- 57.99'
>
> (412) 252-1500 x101 office
> (412) 779-5101 cell
> ----- Original Message ----- 
> From: "sousa, stephen (ENG)" <sousa_stephen at emc.com>
> To: "'Alberg 30 Public List -- open to all'" <public-list at alberg30.org>
> Sent: Monday, August 01, 2005 9:34 PM
> Subject: RE: [Public-list] paint
>
>
> > Dan,
> >
> > To answer your question no. Many Alberg owners have raised the boot
stripe
> > so the water doesn't effect it.
> >
> > Stephen
> >
> > -----Original Message-----
> > From: public-list-bounces at alberg30.org
> > [mailto:public-list-bounces at alberg30.org] On Behalf Of dan walker
> > Sent: Monday, August 01, 2005 9:28 PM
> > To: Alberg 30 Public List -- open to all
> > Subject: [Public-list] paint
> >
> > painting gurus
> > is it a horrible thing if i sand my bootstripe, not completely, fill the
> > spots where the barnacles caused the paint to peel completely with west
> > epoxy(with beads for thickener) then smooth.then put on brightsides.
> > does this question even make since
> > dan
> > call me forrest
> > rascal 145
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Tired of spam?  Yahoo! Mail has the best spam protection around
> > http://mail.yahoo.com
> > _______________________________________________
> > Public-list mailing list
> > Public-list at alberg30.org
> > http://alberg30.org/mailman/listinfo/public-list
> > _______________________________________________
> > Public-list mailing list
> > Public-list at alberg30.org
> > http://alberg30.org/mailman/listinfo/public-list
> >
> >
>
>
> _______________________________________________
> Public-list mailing list
> Public-list at alberg30.org
> http://alberg30.org/mailman/listinfo/public-list
> _______________________________________________
> Public-list mailing list
> Public-list at alberg30.org
> http://alberg30.org/mailman/listinfo/public-list
>
>



 1123161757.0