[Public-list] Nicro Press on Shrouds

[Cole, Andrew L]

Yes, it's me again. 

I went up the mast yesterday to fix a broken Windex and to make a
general inspection of the standing rigging and running fittings.  I
noticed that all of my side shrouds have nicro presses and thimbles at
their upper ends, but have Norseman fittings (or something similar) at
the lower ends.

Are Nicro Presses a normal/safe way to rig the shrouds or should I
prepare to replace the shrouds and/or cut off the nicro presses and add
mechanical terminals to the upper ends (provided there is enough shroud
length/turnbuckle range) when I take down the stick next spring?  The
shrouds appear to be fairly recent and fairly substantial for the size
of the boat (the surveyor concurred).

Thanks, 

Andrew Cole 
Andante # 152  

Cole, Andrew L
Admitted in Maryland, Virginia & Florida
One Corporate Center
10451 Mill Run Circle, Suite 1000
Baltimore MD 21117

 
tel: 410 581-7408
fax: (410) 581-7410
mob: (410) 206-3577

--------------------------------------------------------
This message contains confidential information and is intended only for public-list at alberg30.org. If you are not public-list at alberg30.org you should not disseminate, distribute or copy this e-mail. Please notify andrew.cole at llff.com immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system. E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. Cole, Andrew L therefore does not accept liability for any errors or omissions in the contents of this message, which arise as a result of e-mail transmission. If verification is required please request a hard-copy version.
--------------------------------------------------------

 1124728689.0