[Public-list] Mast Fairing Blocks

[Mike Lehman]

If you have a square block; then I would trace the curve onto the edge of 
the block; then cut it using a bandsaw; then cut out the circle.



Mike Lehman
~~~_/)_/)~~_/)~~~




----Original Message Follows----
From: "Dave Terrell" <DTERRELL at message.nmc.edu>
Reply-To: Alberg 30 Public List -- open to all <public-list at alberg30.org>
To: <public-list at alberg30.org>
Subject: [Public-list] Mast Fairing Blocks
Date: Fri, 18 Feb 2005 15:25:59 -0500

I want to make some mast fairing blocks for the winch and the
footblocks. I have the teak, an accurate template, and understand that
I need to use the template to mark the line that needs to cut.

My question: what sort of tool does one use to cut the wood - and how
does one do it so it is accurate and will fit the mast? The curvature of
the line to be cut is the problem.

Thanks.
_______________________________________________
Public-list mailing list
Public-list at alberg30.org
http://alberg30.org/mailman/listinfo/public-list



 1108760848.0