[Public-list] Rudder shoe pin

[Mike Lehman]

5200 is your answer. Bed the screw in 5200 which will hold it in place. 
Later when you need to remove it, you may do so by applying heat to the 
screw which will soften the 5200 and permit it screw to be removed. That's 
what I would do.



Mike Lehman
~~~_/)_/)~~_/)~~~




----Original Message Follows----
From: Michael Taylor <m_tayau at yahoo.com.au>
Reply-To: Alberg 30 Public List -- open to all <public-list at alberg30.org>
To: public-list at alberg30.org
Subject: [Public-list] Rudder shoe pin
Date: Fri, 8 Jul 2005 02:26:43 +1000 (EST)

My main concern was the 'slop' in the thread.  The pin
is either in hard but when backed out 1/8th of a turn
it is sloppy.  If it works loose in place it will be a
weak point.

Thanks for all the suggestions

Mick






____________________________________________________
Do you Yahoo!?
Try Yahoo! Photomail Beta: Send up to 300 photos in one email!
http://au.photomail.mail.yahoo.com
_______________________________________________
Public-list mailing list
Public-list at alberg30.org
http://alberg30.org/mailman/listinfo/public-list

_________________________________________________________________
On the road to retirement? Check out MSN Life Events for advice on how to 
get there! http://lifeevents.msn.com/category.aspx?cid=Retirement


 1120758366.0