[Public-list] Starboard bulkhead replacement

[Philip Bartlett]

Patty,
I have just discovered some rot in the port side bulkhead while doing some 
wiring. It is below the chainplate attachment which hasn't pulled out yet 
but it needs to be repaired. When you replaced the starboard side bulkhead 
on Timbuktu  how was it done? Was it replaced from the center line out to 
the hull or was a smaller piece scarfed in? Was the new bulkhead material 
glassed in or bolted to the original tabbing?

Has anyone else had to deal with this and how were the repairs made?

Philip Bartlett,
Windward #428


----- Original Message ----- 
From: "Patty J" <Timbuktu5555 at webtv.net>
To: <public-list at alberg30.org>
Sent: Saturday, January 29, 2005 6:20 PM
Subject: [Public-list] Starboard bulkhead replacement


> Aaarrrggh!  My chainplate pulled through the bulkhead.  I think mostly
> to do with the previous owner not calking arount the chainplate, as that
> was the condition I found it in when I bought it 2 years ago.  I
> religiously calked since then, but after the last big race, (20 plus
> knots), not to mention Hurricane Ivan,  found out the ugly truth when I
> saw that my upper shrouds were, well, you could jump rope if you wanted
> to.  Went down below and, oh my goodness, what a mess.  I gotta send
> y'all a picture for sure, before I replace the bulkhead.  It's a beauty
> for sure!
>
> Patty
> Timbuktu #461
>
> _______________________________________________
> Public-list mailing list
> Public-list at alberg30.org
> http://alberg30.org/mailman/listinfo/public-list
> 



 1112241544.0