[Public-list] Zincs

[Mike Lehman]

Brian,

You will need to connect the zinc electrically to the engine. A zinc on the 
rudder will not do much good. Most of us use a zinc on the end of the shaft. 
What I did was to replace the prop nuts with a nut/housing made to take a 
zine. The housing is locked onto the shaft with a cotter pin, then the zince 
fits over it. I think I bought mine at

www.westmarine.com

search for item #:

004_122_003_003



Mike Lehman
~~~_/)_/)~~_/)~~~




----Original Message Follows----
From: Brian Hofler <bhofler at shaw.ca>
Reply-To: Alberg 30 Public List -- open to all <public-list at alberg30.org>
To: Alberg 30 Public List -- open to all <public-list at alberg30.org>
Subject: [Public-list] Zincs
Date: Sun, 20 Mar 2005 20:57:43 -0800

Where are the zincs located on A30's. This is the first time I have taken
our boat out of the water since purchasing her last fall. I can see no
evidence of a zinc on the shaft, aft of the prop, or elsewhere on the hull.
I am considering bolting a zinc right through the rudder, the type that is
domed about 3-4 inches in diameter. Any problems in doing so? Any other
suggestions?

Thanks
Brian - Putachieside - 496




__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
Public-list mailing list
Public-list at alberg30.org
http://alberg30.org/mailman/listinfo/public-list
--
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.7.3 - Release Date: 3/15/2005

--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.7.3 - Release Date: 3/15/2005


_______________________________________________
Public-list mailing list
Public-list at alberg30.org
http://alberg30.org/mailman/listinfo/public-list



 1111410664.0