[Public-list] (no subject)

[John Boor]

> Roger and Stephen

I have one photo of work in progress, I would like to take
some more to show the finished battery box area with
batteries installed and can do this in the next day or two. 
I understand that I cannot send attachments to the alberg
site directly so will send them to George for inclusion on
the site.

John Boor
MAHSEER #380
> 
> It would be nice to have photo's of the rework.
> 
> Stephen 
> 
> 
> 
> John (Boor),
> 
> Do you have photos of your battery install?  Did you
> enlarge the hatches in the sole to make room for the
> batteries?
> 
> Roger
> 
> ----- Original Message ----- 
> From: "John Boor" <5thseason at canada.com>
>
> > > I have been there on 380 as Roger states the ballast
> > slopes to the aft end of the keelcavity, and is about
> > 12in deep just before it passes through the engine
> > compartment bulkhead.  I found that all of the lateral
> > stringers had rotted out at the base due to excessive
> > water intrusion over the years and I had to replace
> > them.  Check to make sure all the limber holes are open
> > and you have a natural slope into the bilge area.  Since
> > I was in this part of the boat I reworked the battery
> > box area to accomodate 4 6volt deep cycle batteries and
> > a starting battery and still allow water to folw through
> > from the forward section to the bilge.  Also as Roger
> > states the cabin sole is only fastened at the lateral
> > stringers and filler used to blend the sole into the
> > hull and settee bulkheads. John Boor
> > #380
> > MAHSEER
>


----------------------------------------
Upgrade your account today for increased storage; mail
forwarding or POP enabled e-mail with automatic virus
scanning. Visit
http://www.canada.com/email/premiumservices.html for more
information.

 1130332538.0