[Public-list] vent loop height

[sousa, stephen (ENG)]

Dan,

Someone on the list suggested using a heat gun and KY Jelly to make it
easier for the fittings to go together. I used both suggestions and they
worked well, without the heat gun it was a night mare trying to make the
loops. The Vented Loop needs to be above the waterline when laying over, I
would think that the pressure required to move water would increase as the
height increases for the loop. The loop in #114 is at or about the toe rail
height.

Hope this helps.

Stephen 

-----Original Message-----
From: public-list-bounces at alberg30.org
[mailto:public-list-bounces at alberg30.org] On Behalf Of dan walker
Sent: Thursday, September 22, 2005 11:08 AM
To: Alberg 30 Public List -- open to all
Subject: [Public-list] vent loop height

as i replace hoses and parts on the head, it is easier to make some bends if
they are longer. consequently, the question, is there an optimal height for
the vented loop, specifically, can it be too high.
dan
rascal145
 

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-list mailing list
Public-list at alberg30.org
http://alberg30.org/mailman/listinfo/public-list

 1127405823.0