[Public-list] Zinc

[Mark Ferguson]

I must have a different setup. I only have 1" from the rear of the prop to the end of the shaft. I don't think the bullet anode will fit. The fitting where the shaft leaves the hull takes up 4''.
============================================================
From: FINNUS505 at aol.com
Date: 2006/03/31 Fri PM 10:00:13 EST
To: public-list at alberg30.org
Subject: Re: [Public-list] Zinc

 
In a message dated 3/31/2006 5:58:12 PM Eastern Standard Time,  
dickdurk at atlanticbb.net writes:

7/8  thread bullet zinc. You'll probably have to hack saw 
off trailing tip to  get it to fit in front of the rudder. 
I usually buy out Fawcett's  inventory (Annapolis) when I 
go there, but it has been a couple of years,  they should 
have them.

Is the guppy system where you have some  metal laying in 
the bottom of the bilge? You may have other  issues...

MichaelGrosh
#220



When the bullet zinc is put on the end of the shaft, you can't use the  
cotter pin anymore, right? Any one had any problems because of this?
 
And,
what is the 'guppy system'? :)
 
Thx,
Lee
Stargazer #255
_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-list mailing list
Public-list at alberg30.org
http://alberg30.org/mailman/listinfo/public-list
============================================================



 1143913737.0