[Public-list] Removal of brass temperature sensor

Peter Manika pmanika at sbcglobal.net
Sun Jul 16 10:44:14 PDT 2006


Be careful putting teflon tape on the threads as you might lose your ground. The temp sensor grounds the body to the block.
  Pete  156

Gordon Laco <mainstay at csolve.net> wrote:
  The bayonet connector on the heat sensor in my MG's engine was always
falling off...so one day I decided to solder it on...then I wondered why the
temp gauge seemed to no longer work. That night while going to sleep I
realized that applying a lot of heat to a heat sensor might not have been a
good idea...

;) 





> On most mechanical parts ...
> 
> Heat will help but the one that said heat the brass fitting directly is
> WRONG!
> TO free a stuck bolt,threaded fitting ALWAYS heat the metal of the
> surrounding area being sure not to heat the the actual threaded fitting
> you are removing.
> 
> You might - since you motor is running fine, run the motor for a time to
> get the entire block warmed up. Soak the area at the threads with WD-40 or
> my favorite DeepCreep(Seafoam). Then add a little extra heat around the
> area of the temp sensor on the Head. then try turning off with a VERY
> LARGE Crescent Wrench. These work best as you will NOT slip. A grip wrench
> will destroy the surface area. Though that may not be an issue ... it may
> be in the long run.
> 
> That shuold do it.
> 
> Also on putting the new sensor in - Use teflon tape around the threads
> just like plumbing.

_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-list mailing list
Public-list at alberg30.org
http://alberg30.org/mailman/listinfo/public-list


 1153071854.0


More information about the Public-List mailing list