[Public-list] shaft coupling removal

[dan walker]

so i can use a gear puller and do the same ? right? only the set screw and rust hold the coupling to the shaft?
  thanks mike
  dan

Mike Lehman <sail_505 at hotmail.com> wrote:
  Dan,

Seperate the flanges; remove/replace the bolts with longer ones; remove the 
set screw on the coupling; place a socket (smaller than the shaft) between 
the flanges; tighten te bolts which allow the socket to push the shaft out 
of the coupling as the two flanges come together. It's easy.



Mike Lehman
~~~_/)_/)~~_/)~~~




----Original Message Follows----
From: dan walker 
Reply-To: Alberg 30 Public List -- open to all 

To: Public-list at alberg30.org
Subject: [Public-list] shaft coupling removal
Date: Thu, 15 Jun 2006 10:21:07 -0700 (PDT)

any tricks to removing the coupling that is on the shaft?
dan
rascal 145

__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-list mailing list
Public-list at alberg30.org
http://alberg30.org/mailman/listinfo/public-list

_________________________________________________________________
Is your PC infected? Get a FREE online computer virus scan from McAfee® 
Security. http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963

_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-list mailing list
Public-list at alberg30.org
http://alberg30.org/mailman/listinfo/public-list


 __________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
 1150399252.0