[Public-list] Cockpit floor

[Robert Gainer]

Sorry, for cutting the glass in the cockpit I was way off. A dremel is too small a tool and a skill saw with a cutoff disk is the way to go. I did not read the intended use of the tool before I jumped in.
Robert Gainer

> 
> From: George Dinwiddie <gdinwiddie at alberg30.org>
> Date: 2006/03/13 Mon PM 07:03:28 EST
> To: Alberg 30 Public List -- open to all <public-list at alberg30.org>
> Subject: Re: [Public-list] Cockpit floor
> 
> Gordon Laco wrote:
> > In my case I am
> > going to cut around the whole cockpit floor with a rotary cutting tool whose
> > depth I can regulate (some-one tell me what the thing is called please)
> 
> A skil-saw.  At least, that's what I used.  Use an old one; glass is 
> hell on the bearings.  Today I'd probably just use the 4" grinder.
> 
> > I have a fond
> > hope that I can remove the top layer intact and glue it back down.  If not I
> > will be painting the new top surface.
> 
> I used foam coring, and laid up new glass on top.  Then I painted and 
> put non-skid in the paint.
> 
> > Funny thing is the only part of the job I don't have full confidence in is
> > getting the rudder head casting off.  Does anybody have any suggestions?  I
> > don't imagine it will come off easily even after I back off the bolt.
> 
> Mine came off fairly easy, with a little bit of upward hammering with a 
> wood block.
> 
>   - George
> 
> -- 
>   ----------------------------------------------------------------------
>    When I remember bygone days                         George Dinwiddie
>    I think how evening follows morn;            gdinwiddie at alberg30.org
>    So many I loved were not yet dead,           http://www.Alberg30.org
>    So many I love were not yet born.
>                 'The Middle' by Ogden Nash
>   ----------------------------------------------------------------------
> 
> 
> 
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-list mailing list
> Public-list at alberg30.org
> http://alberg30.org/mailman/listinfo/public-list
> 


 1142295628.0