[Public-List] Holding tanks

[andymshaw at juno.com]

A-men to that. I was just thinking after reading all this discussion of hoses and odors and standing sewage that "gosh, I'm glad I have an airhead"
Andy    #477                                                                                                                                                                         

-- Brian Hofler <bhofler at shaw.ca> wrote:
Or better yet...install an airhead...

Brian - #496

-----Original Message-----
From: public-list-bounces at lists.alberg30.org
[mailto:public-list-bounces at lists.alberg30.org]On Behalf Of Don Lang
Sent: Sunday, April 13, 2008 6:49 PM
To: public-list at lists.alberg30.org
Subject: Re: [Public-List] Holding tanks


I attended a marine sanitation seminar this winter; here is a few things I
learned:

Any type of flexible hose that contains standing sewage will be permeated by
the sewage and cause odors.
Therefore whenever possible use schedule 40 PVC (not ABS its too brittle)
and not flexible hose, and always use PVC
for all lines that will hold standing sewage. Keep flexible hose runs as
short as possible.
Use PVC hose barbs for tanks fittings and not maralon, nylon etc. as they
will also be permeated over time.
When using flexible sanitation hose you may warm the end gently with a heat
gun to make it easier to connect, never use soaps or oils, etc.
When comparing sanitation hoses (apples to apples) the less flexible the
hose, the longer it will take to become permeated and cause odors.
They said the more flexible the hose, the further apart the molecules that
make it up are; fewer molecules = more easily permeated.
Not sure if the hose is causing the odor you smell; wipe it with a clean
cloth and take the cloth outside into fresh air, if the hose is permeated
the cloth will smell.
If you use a holding tank filter on the vent line ensure that you change it
out if it becomes wet and there is no low spots in the line that can
restrict the vent.
Dock-side suction pumps can pull over 30 psi and a restriction in the vent
line (or undersized vent)   causes many tank and fitting failures  and can
fatigue tanks and fittings even it it does not cause them to fail at that
particular instance.

Cheers, Don (#473)





George,
I  took delivery this week of a 14 gal holding tank (14D20814) to install in
Ginseng, Hull # 574, ordered from Raritan Engineering Inc.
I read the Raritan holding tank installation article you posted on the
Alberg 30 site and was wondering in hind sight if there was anything you
would do differently now that you have had it installed for a number of
seasons?
Peter Milley







__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
No virus found in this incoming message.
Checked by AVG.
Version: 7.5.519 / Virus Database: 269.22.13/1375 - Release Date: 4/12/2008
11:32 AM

No virus found in this outgoing message.
Checked by AVG.
Version: 7.5.519 / Virus Database: 269.22.13/1375 - Release Date: 4/12/2008
11:32 AM

_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org


_____________________________________________________________
Hotel pics, info and virtual tours.  Click here to book a hotel online.
http://thirdpartyoffers.juno.com/TGL2121/fc/Ioyw6i3nLmKspW2f7U1lcuRjaecsv0NOcCJJ11441zUq2p8XuE0RiI/

 1208195022.0