[Public-List] Tiller end fittings question

[Daniel Sternglass]

Hi all,

It's been a long time since I've posted to this list.... After several 
repairs including some machining and wedging brass washers into the 
tiller end fitting, I think it's time for me to replace the tiller end 
"H" fitting and probably the fitting atop the rudder post. Any 
recommendations? Ideally, I'd be able to continue to use the existing 
teak tiller, if the same fitting or one very close were abatable. 
Depending on the cost, another alternative is have a local machine shop 
make me new parts, but that might be significantly more expensive than 
something commercially available...

Thanks,

--Dan Sternglass
dans at stmktg.com
Watcher of the Skies, A-30 #201, 1966, Cayuga Lake, Ithaca, NY