[Public-List] Water Tank

[Elyse Pastor]

Hello Michael
Thank you for your reply. It seems that in hull 297 has a distinct water 
tank. I can see the v shape of the tank and it is separated fom the hull 
near the v-bert seat. However, I do not know if it goes all the way to the 
front or if it joins somewhere the hull?!
I will go look at it again this week.
Regards
Bruno & Elyse
Lady Heron 297


>Message: 5
>Date: Mon, 27 Oct 2008 00:21:47 +0000 (UTC)
>From: crufone at comcast.net
>Subject: Re: [Public-List] Water tank on pre-liner boats
>To: Alberg 30 Public List -- open to all
>	<public-list at lists.alberg30.org>
>Message-ID:
>	<956741146.864141225066899787.JavaMail.root at sz0102a.westchester.pa.mail.comcast.net>
>
>Content-Type: text/plain; charset=utf-8
>
>
>
>My understanding is that the foreward water tanks on the preliner boats are 
>not tanks at all, but just a cover over a bulkward at the rear side.? The 
>two lower sides are fromed from the inside of the boat hull.
>
>
>
>Michael
>----- Original Message -----
>From: "Elyse Pastor" <elyse.pastor at sympatico.ca>
>To: public-list at lists.alberg30.org
>Sent: Sunday, October 26, 2008 7:53:32 PM GMT -05:00 US/Canada Eastern
>Subject: [Public-List] Water tank on pre-liner boats
>
>Hello Albergers,
>Now that the Boat is out of the water, I had the time to start my first
>project of installing a holding tank.
>First I removed the wooden plank of the V-Bert port side by drilling out 
>the
>screws (I had to scrape the paint away to find where the screws were
>located). On the hull side, the wooden plank was solidely tabed with
>fibreglass to the hull. So I used my car-jack and lifted the hole plank
>until the joint broke cleanly off the wood (the tabing is still there).
>Then I repeated the same on the starboard side as I also wanted to look at
>the water tank.
>This watertank is a solid fibreglass tank that is heavily tabed along the
>left and right side to the hull and to the wood structure (seat) of the
>V-bert. Unfortunaetly this tank has no alu-cover as described in several 
>old
>Forums. I assume, this is because it is a pre-liner boat.
>I would like to cut-the tabing on the 3 sides and remove the tank and
>replace it with a new one. My question - does the tank have any structural
>function, considering the tank is heavily tabed along the left and right
>side to the hull?
>With best regards
>Bruno & Elyse
>Lady Heron #297
>
>



 1225153917.0