[Public-List] Holding Tank Installation - what tank are you putting back in?

[Jonathan Adams]

I took a sabre saw and made the hatch that was there big enough to pull the old tank out,and then I remade the hatch so I could close it up.
 
I never replaced the tank - I use a porta potti, but I have been looking for a tank that will fit that did not cost an obscene amount. Have you found one? Everything on the web site is for the newer boats.
 
Jonathan
197



----- Original Message ----
From: Elyse Pastor <elyse.pastor at sympatico.ca>
To: public-list at lists.alberg30.org
Sent: Monday, September 29, 2008 10:07:32 PM
Subject: [Public-List] Holding Tank Installation

Hello Albergers,
James McRury's e-mail just reminded me about my own winter project of 
installing a holding tank below the port side v-berth (as per web site).
I tried to figure-out on how to remove the horizontal wooden panel (the 
panel on which the port side mattress is lying)?
It seems that the edge towards the hull is tabbed with fiberglass.
My question to those Albergers who have already done that job of installing 
a holding tank - how did you start the project in this regard? (We have a 
no-liner boat)
Thanks in advance for some advise.
Bruno & Elyse
LADY HERON 297


_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org

 1222742328.0