[Public-List] Seacocks and gate valves.

[J Bergquist]

John-

There was a really good article in Professional Boat Builder magazine
a few issues back about replacing through-hulls.

http://www.proboat-digital.com/proboat/20080809/

Not sure if it will help you, but I thought it was worth reading.

Heard you are going cruising this summer. Enjoy!

J

On Sun, Apr 12, 2009 at 8:02 AM, John Flanders <johnflanders at rogers.com> wrote:
>>
> I am finally getting around to replacing the original gate-valves on my boat
> Sam. The 1 and 1/4 inch sink drain valve is frozen solid on the through hull
> fitting. Has anyone any suggestions on how to get this gate-valve off
> without doing too much damage. I have a similar problem with the i/2 inch
> engine water intake, which I propose to replace with a 3/4 seacock.
> John Flanders
> Sam 624
>
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>

 1239538258.0