[Public-List] Bulkhead Repairs

[Roger L. Kingsland]

RE dust while cutting; I sometimes jury rig (duct tape) the sucking end of
my shop vac to the power tool to try and catch dust (a helper manning the
vacuum works better).  Helps allot but still not perfect. 

Roger 148

-----Original Message-----
From: public-list-bounces at lists.alberg30.org
[mailto:public-list-bounces at lists.alberg30.org] On Behalf Of Michael Taylor
Sent: Tuesday, September 08, 2009 3:27 PM
To: public-list at lists.alberg30.org
Subject: Re: [Public-List] Bulkhead Repairs

Hi Jim,


If you are cutting the tabbing keep in mind the dust issue.  I seriously
under estimated the mess I would make removing the knees in for the lower
forward shroud chain plates.  If the boat isn't stripped down then put in
lots of time to put up a barrier for the dust you are going to create.

cheers

Mick




 
____________________________________________________________________________
______
Get more done like never before with Yahoo!7 Mail.
Learn more: http://au.overview.mail.yahoo.com/
_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org


 1252439993.0