[Public-List] Stephen -Whale gusher 10 pump

[Richard J Hughes]

A kit for the whale gusher is still readily available.  If the nut is 
screwed so is likely the rest. Change the nut, diaphragm, and the two rubber 
flap intake/outflow while you're at it.

--------------------------------------------------
From: "Stephen Gwyn" <gwyn at beluga.phys.uvic.ca>
Sent: Saturday, September 18, 2010 10:04 PM
To: <public-list at lists.alberg30.org>
Subject: [Public-List] Whale gusher 10 pump

>
> Hi,
>
> I took apart my manual bilge pump. It's a whale gusher
> 10, like most or all Alberg 30s. It mostly looks OK except
> for one nut on the inside of the diaphragm, on the end of
> the bolt going through the diaphram. This fell apart when
> I tried to remove it. It looks like it should be a 1/2 inch
> coarse threaded nut, but when I bought one it wouldn't
> go on. Is it some kind of metric nut? Or is it special
> to Whale pumps? It look like it was aluminum. Should
> buy the 99$ kit just for the nut, or should replace
> the nut with SS if/when I can find the right size?
>
> Anybody have experience with this?
>
> Stephen
> Quasar #495
>
>
>
> ------------------------------------------------------------------
>  Stephen Gwyn                 |  Tel: 1-250-363-3136
>  Dept. of Physics & Astronomy |  Fax: 1-250-363-0045
>  Univ. of Victoria            |  Cell: 1-250-885-6969
>  PO Box 3055                  |  E-mail: gwyn at uvastro.phys.uvic.ca
>  Victoria, BC  V8W 3P6        |  http://orca.phys.uvic.ca/~gwyn
> ------------------------------------------------------------------
>
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org 


 1284873933.0