[Public-List] block sized

[crufone at comcast.net]

Roger, 

I suspect that the tapered edge goes aft. At any rate the spreaders after installed must be swept aft. 

Michael #133 
----- Original Message ----- 
From: "Roger L. Kingsland" <r.kingsland at ksba.com> 
To: "Alberg 30 Public List -- open to all" <public-list at lists.alberg30.org> 
Sent: Tuesday, May 31, 2011 2:38:07 PM 
Subject: [Public-List] block sized 

Hi Folks, 

  

Working on the mast; spreaders went on OK (the tapered side of the wood ones 
goes forward, right?), need to replace topping lift and spinnaker halyard 
blocks.  I have a couple of Harken bullet blocks with a 485 lb working load. 
I assume one will be OK for the topping lift but wonder about the spin 
halyard.  Any suggestions as to working load for the block? 

  

Thanks, 

  

Roger 

  

  

  

Roger Kingsland, Managing Partner 

Kingsland Scott Bauer Associates 

  

KSBA 

  _____   

Architects/Planners/InteriorDesigners/ProjectManagers 

  

3441 Butler Street 

Pittsburgh, PA 15201 

N 40° 27.8344'  W79° 57.9831' 

  

412-252-1500 ext.101 

412-779-5101 cell 

412-252-1510 fax 

 <blocked::blocked::mailto:r.kingsland at ksba.com> r.kingsland at ksba.com 

 <blocked::blocked::http://www.ksba.com/> www.ksba.com 

  

  

_______________________________________________ 
These businesses support your Association: 
http://www.alberg30.org/store/A30supporters.html 
Please support them. 
_______________________________________________ 
Public-List mailing list 
Public-List at lists.alberg30.org 
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org 

 1306871354.0