[Public-List] Early model running light question2

[Amy & David Swanson]

Stephen -

So just to clarify, you drove them out toward teh lens (if the lens was 
still installed)?  I will give that a try.

Thanks

David Swanson
Strayaway Child
Alberg 30 #229
----- Original Message ----- 
From: "Stephen Gwyn" <gwyn at beluga.phys.uvic.ca>
To: <public-list at lists.alberg30.org>
Sent: Tuesday, October 11, 2011 1:59 AM
Subject: Re: [Public-List] Early model running light question2


>
> I removed the light sockets (which are a very tight fit in
> their holes) by climbing into the anchor locker with
> my socket wrench set. I picked a socket just smaller
> than the hole, one with a long shaft. I stuck it
> up through the hole so it rested against the bottom
> of the plastic light socket. A few gentle taps
> and it popped up. You could use a screw driver,
> but that would wreck the plastic socket.
>
> Stephen Gwyn
> #495 Quasar
>
> ------------------------------------------------------------------
>  Stephen Gwyn                 |  Tel: 1-250-363-3136
>  Dept. of Physics & Astronomy |  Fax: 1-250-363-0045
>  Univ. of Victoria            |  Cell: 1-250-885-6969
>  PO Box 3055                  |  E-mail: gwyn at uvastro.phys.uvic.ca
>  Victoria, BC  V8W 3P6        |  http://orca.phys.uvic.ca/~gwyn
> ------------------------------------------------------------------
>
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org 


 1318635978.0