[Public-List] Cutlass Bearing and stuffing box

[Bob Norway]

BTW, the complete kit from Buck Algonquin included the hose....

Cheers,
Bongo Bob Norway
_________________
S/V Beowulf #488
_________________
Manatee Cove Marina Website Webmaster
http://mcmpix.shutterfly.com
_________________
TLCB Webmaster
www.tlc-brotherhood.org  
_________________
http://airforce.togetherweserved.com/profile/88355
___________________
SpaceCoast Parrot Heads Club Webmaster
http://spacecoastparrotheads.webs.com   

~~~~~
 Õ¿Õ¬
  ~~
   V


-----Original Message-----
From: public-list-bounces at lists.alberg30.org
[mailto:public-list-bounces at lists.alberg30.org] On Behalf Of Bob Norway
Sent: Tuesday, September 20, 2011 23:02
To: 'Alberg 30 Public List -- open to all'
Subject: Re: [Public-List] Cutlass Bearing and stuffing box

I got my Cutlass bearing from Lewis Marine. It was a Duramax Cutless Naval
Brass Shelled Marine Bearing. I believe the Part # is APEX. The stuffing box
was from Buck Algonquin part # PB88. Both were for 7/8" shaft size. Again,
both available from Lewis Marine. Good luck.

Can't help you on the main hatch.

Cheers,
Bongo Bob Norway
_________________
S/V Beowulf #488
_________________
Manatee Cove Marina Website Webmaster
http://mcmpix.shutterfly.com
_________________
TLCB Webmaster
www.tlc-brotherhood.org  
_________________
http://airforce.togetherweserved.com/profile/88355
___________________
SpaceCoast Parrot Heads Club Webmaster
http://spacecoastparrotheads.webs.com   

~~~~~
 Õ¿Õ¬
  ~~
   V

-----Original Message-----
From: public-list-bounces at lists.alberg30.org
[mailto:public-list-bounces at lists.alberg30.org] On Behalf Of randall
weatherspoon 
Sent: Tuesday, September 20, 2011 22:18
To: public-list at lists.alberg30.org
Subject: [Public-List] Cutlass Bearing and stuffing box

Does anyone know where I can get a new cutlass bearing and stuffing box and
I suppose the hose that goes on the stuffing box too. I was going to turn
down a little of the stuffing box but too much electrolysis damage.

 

Has anyone rebuilt the main hatch - how do you get the curvature?

 

Thanks.

Randy - Marisel #385

_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org

_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org


 1316575040.0