[Public-List] The A4 motor mystery??

moiraeiii at aol.com moiraeiii at aol.com
Tue Sep 27 05:03:34 PDT 2011


Agree... exhaust restriction will stall the A4. Is there 'proper' water exiting the exhaust? Rodents or avian types may have set up housekeeping in the exhaust  system during the layup. Another possibility is low oil pressure safety switch if so installed. Usually installed with electronic fuel pump, but sometimes used in mechanical fuel pump installations. (cuts off voltage to the coil).

Randy
MOIRAEIII #283




-----Original Message-----
From: mahseer <mahseer at kos.net>
To: Alberg 30 Public List -- open to all <public-list at lists.alberg30.org>
Sent: Tue, Sep 27, 2011 3:33 am
Subject: Re: [Public-List] The A4 motor mystery??


Jacques.

The strangest problem I have had to deal with on an A4 had the same
symptoms as you describe, the problem turned out to be a frozen closed
back flow preventor in the exhaust line causeing high back pressure and no
air flow through the carb.

John Boor
MAHSEER #380


> Dear Atomic 4 devotees,
>
>
>
> I have had a mysterious problem with my A4 this summer and have not yet
> found the cause.  I posted here earlier this summer and received some good
> advice early in my A4 mechanical journey.  Because of my work outside
> Canada, my Alberg 30 was on the hard for 3 seasons.  It was well covered
> and
> looked very good this spring.  We installed three new group 27 gel
> batteries
> and launched her.  To our surprise the engine would not start?  The engine
> has never had a mechanical problem in its 40 yr. life.  Upon inspection we
> discovered that there was no spark.  There was a current to the coil with
> the ignition switch on.  The assumption was that there was a problem with
> the coil.  We also changed the points, condenser and distributer cap.  We
> ordered a new coil and when it arrived we installed it and discovered that
> the main wire from the distributer cap to the coil was heavily corroded
> and
> fell apart when being removed.  We order a new wire and assumed that it
> was
> at the route of our problem and not the new coil.  It was probably time to
> renew the old coil after 40 years.  We then tried to fire up the engine
> but
> with no success.  Again no spark from the coil wire or sparkplugs.  After
> considerable advice and testing we finally found that although there was
> current (ground) to the coil when the ignition key was turned on, that was
> not the case when we further turned the key to engage the starter.  This
> explained the lack of spark when trying to turn the engine over to start.
>
>
>
> To quickly bypass the problem we grounded the coil directly to the engine.
> It then started on the first turnover and ran smoothly for a couple of
> minutes then abruptly stopped!!  It would not start again until we waited
> for about 15 to 20 minutes.  It would then start and run for a minute or
> two????  The consensus of interested parties and myself was that the
> carburetor must be the problem???  (Before leaving the boat on the hard
> for
> the 3 years we had filled the tank to full.  Before launching this spring
> we
> emptied the tank and refilled it with fresh gas.)  I then brought the carb
> home and cleaned it and adjusted the floats as best I could, expecting
> that
> this would finally solve the problem??  When I tried to run the engine
> with
> the cleaned carb I again had the same result.  It would start and run for
> a
> minute or two and then stop abruptly.  At this point we had missed half
> the
> season so in desperation I order and installed a new carborator.  Again
> the
> same result???  The best guess from me and the interested parties was that
> the carb was not getting enough gas from the tank.  To test that
> hypotheses
> I disconnected the gas line and ran it up to a separate gas container.
> When
> I started the engine it repeated its previous problem and ran for only a
> minute or two???
>
>
>
> The only component we have not yet touched is the fuel pump.  Should I
> replace the fuel pump with an electric one and believe that this will
> solve
> my problem?????  The container I drew the gas from was higher than the
> fuel
> pump and I would expect that gravity would feed the gas through the pump
> to
> the carb. even if the pump were defective  ???? .
>
> I should also add that I checked the compression.  It tested evenly across
> the 4 cylinders at about 107.  They tell me that this is good.  The engine
> does not burn any oil that I can measure.
>
>
>
> I'd be interested in any advice you all might have on: a) how to fix my
> problem and b) does it sound like a fuel pump problem???  My next step is
> to
> seek a religious intervention??
>
>
>
> Thanks,
>
> Jacques Dusseault
>
> Kilwinning #446
>
> 613-220-2230
>
> dusseaultj at gmail.com
>
>
>
>
>
>
>
> Jacques M. Dusseault
>
> President,
>
> Synergem Management Inc.
>
> Tel: 819-561-1268
>
> Cell: 613-220-2230
>
> Email: jdusseault at synergem.org
>
>
>
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>

_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org

 

 1317125014.0


More information about the Public-List mailing list