[Public-List] Marisel #385 projects

[randall weatherspoon]

I am making progress on several fronts;

 

1.       I assume the main hatch slides back & comes off if you remove the
two vertical wood strips on either side of the hatch - don't want to remove
the strips if that is not right? I don' have time to rebuild so will
probably just glass for now.

2.       I finally have the old mast section blank machined and ready to
make a new masthead and base to be machined - was wondering about writing up
the whole process for the site as it has been quite an ordeal and expense. I
still have the top of the head to finalize. Where would I send pics for the
site to have posted?

3.       I have found a rubber insert for the stuffing box hose (1.5 to
1.25) but need to sand down a little as it is too big when over the stern
tube to go into the hose. A friend made a mandrel the same size as the stern
tube to test and also to use to sand down the insert.

4.       My last major project is the exhaust. The old muffler was looking
pretty weak at the bottom and any leaks  would immediately put about a quart
of water into the engine - I was thinking of just using iron pipe and the
Moyer fitting but wasn't sure if I needed the expansion or cooling like the
old muffler.  I visited Peter Amos and he just has the pipe which works so
don't see the need for the expense - although that would also bias the
Compass --?would Stainless Steel effect the compass? - I will probably go
with Peter's design.

5.       I also have some nice pics of what appear to be the old through
hulls with the washer --- The through hull looked sound until I put vise
grips on it and it crumbled like chalk - glad I took it out but was very
deceptive.

 

I have pics on a lot of this if anyone is interested.

 

Randy Weatherspoon

Marisel #385

 


 1326084469.0