[Public-List] Masthead

[Lawrence Morris]

There is a design out there because some boats from annapolis area replaced theirs a couple of years back. 

Anyone remember the supplier?

Sent from my iPhone

Larry Morris

On Mar 4, 2012, at 4:48 PM, Glennb <brooks.glenn at comcast.net> wrote:

> Hi Randy, 
> 
> I am also looking to replace my masthead fitting.  are you having yours machined out of solid stock or welded up?  Would your yard do a second one if I sent my mast dimensions?
> 
> Don't know why the bavstay fitting is higher... Maybe to compensate for springing the mast aft when setting up tension??
> 
> Cheers
> Glenn B
> Dolce in Seattle
> 
> Sent from my iPad
> 
> On Mar 4, 2012, at 10:21 AM, "randall weatherspoon " <rlwspoon at earthlink.net> wrote:
> 
>> I 'm having a new masthead machined and was going to make the forestay and
>> backstay pins at the same level to save weight but was wondering - does
>> anyone know why on the original masthead the backstay pin is about a half
>> inch higher than the forestay pin. I've looked around the yard and there are
>> several of each type. Any thoughts?
>> 
>> Thanks
>> 
>> Marisel #385
>> 
>> _______________________________________________
>> These businesses support your Association:
>> http://www.alberg30.org/store/A30supporters.html
>> Please support them.
>> _______________________________________________
>> Public-List mailing list
>> Public-List at lists.alberg30.org
>> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org

 1330903816.0