[Public-List] Wires into the boat

[Mike Lehman]

These are terrific...the only thing that I have found that does not leak. 
Like many of you, I led the wires behind the beam into the locker behind the 
head and installed a terminal strip. I left the wire long, created a service 
loop, so when I take the mast down again, if I have to cut off the ring 
terminals, I have plenty of wire left.




~~~_/)_/)~~ Mike Lehman ~~_/)~~~


-----Original Message----- 
From: Greg Bover
Sent: Thursday, August 29, 2013 3:51 PM
To: A-30 List
Subject: [Public-List] Wires into the boat

Hello Jeff,
I prefer the Blue Sea Systems clams
<http://www.bluesea.com/products/category/Clam>  and I have one on each side
of the mast. I used the sizes large enough to put all the connectors inside
the boat just forward of the mast beam in the v-berth. The self-amalgamating
tape helps make a round bundle of the multiple wires on one side and the
flat duplex goes through an oval hole on the other. I didn't freeze the
rubber, although that sounds like a good trick. I did use bi-spur bits
instead of twist bits for a nice clean hole and then made a slit to the hole
with a scalpel to make installing the wire easier. I squirt a little
silicone on the top to help stop any minor leaks. BTW I used far fewer than
100 cable ties on the bundle inside the mast. I put one every 12-16" and
just spiraled them around once every three ties. Blessed silence after two
years of listening to them slap at anchor.

Greg Bover
A-30 #114
LINNET
Gloucester

Jeff wrote: I'm wondering what everyone else has set up to get the wires
from the mast
into the boat?


_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org 


 1377864344.0