[Public-List] Interior/Cabin Paints

via Public-List public-list at lists.alberg30.org
Fri Dec 9 08:59:54 PST 2016


Hello again,

Forget to mention, I did exactly what you intend to do for the pegboard area.  I epoxied the vertical strips back in place and screwed a ceiling to them (used cedar strips for the smell) stained and oiled to match cabinetry!  Very salty improvement!

Cheers,

Maurice


---- Original Message ----
From: via Public-List <public-list at lists.alberg30.org>
To: 262alberg30 <262alberg30 at gmail.com>; public-list <public-list at lists.alberg30.org>
Sent: Fri, Dec 9, 2016 11:50 am
Subject: Re: [Public-List] Interior/Cabin Paints

Hello Jonathan

I applied three coats of Tremclad white high gloss (canadian equivalent to Rustoleum I think), used a bit more than 2 gallons.  That includes behind the pegboard, which I removed and tossed, and in all lockers above the waterline.  I did not sand much but scraped off all peeling paints and really washed and scrubed the interior before painting with a potion of TSP, Mr. Clean and chlorine, wear gloves!  Use good paint brushes and a 4 inch roller and slather it on thick and go back to clean up drips.        

It is holding up very well after three years, easy to clean and makes for a bright and shiny interior.  Have fun and yoga really helps for the contorsions you are about to engage in!

Cheers,

Maurice


---- Original Message ----
From: Jonathan Bresler via Public-List <public-list at lists.alberg30.org>
To: Alberg 30 Public List -- open to all <public-list at lists.alberg30.org>
Sent: Fri, Dec 9, 2016 10:35 am
Subject: [Public-List] Interior/Cabin Paints

Folks,

Took a look at Practical Sailor to see which paints they recommend for
painting the overhead, interior of the lockers, etc.  No joy.  Didn't find
a single article about interior paints.  Deck paints, topside paints,
bottom paints, bilge paints are all covered, but not interior paints.

No doubt that this has been discussed before, wondering what folks are
using now.  What have folks used and decided not to use again.

The motivating item here is that I removed the Masonite(?) pegboard in the
v-berth which is used to cover the hull on port and starboard from the top
of the v-berth to the underside of the deck.  Behind the v-berth is a
"lovely yellowish" color.   The wife will NOT be happy with that.  The
pegboard one each side of the v-berth was screwed to five shaped teak
strips oriented vertically.  Nearly all the teak strips were loose. Now
they are all loose and have been labeled for reinstallation.  The teak
strips were attached to the hull with three very generous globs of
fiberglass resin(?) each.  The globs are so thick that there was a clear
gap between the teak strips and the hull.  Need to reattach these strips
and paint the sides of the hull and the overhead before attaching a ceiling
to the strips.

Couple photos available on request.

Jonathan

-- 
Jonathan M Bresler
S/V Constance Alberg 30 #262
Annapolis/Eastport MD
_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org

_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org



More information about the Public-List mailing list