[Public-List] Stern tube

Kris Coward via Public-List public-list at lists.alberg30.org
Wed Jun 15 08:19:38 PDT 2016


The water holes for lubricating and cooling the cutless bearing and
stuffing box are at the forward end of the stern casting, one on each
side of the casting (and need to be drilled into the bearing when
replacing it; be careful to drill nice and slow, with a sharp bit and
plenty of cutting fluid, so that pressure from the drill doesn't deform
the bearing).

-Kris

On Wed, Jun 15, 2016 at 11:15:10AM -0400, Bob Bohmer via Public-List wrote:
> Might be tangential, but it is my understanding that the boats with a 7/8"
> shaft don't have ( mine didn't) holes for cooling.  Is it necessary and if
> so, where is the best location for them?
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org

-- 
Kris Coward					http://unripe.melon.org/
GPG Fingerprint: 2BF3 957D 310A FEEC 4733  830E 21A4 05C7 1FEB 12B3



More information about the Public-List mailing list