[Public-List] Head plumbing

George Dinwiddie gdinwiddie at alberg30.org
Thu Dec 28 15:56:36 PST 2017


Stephen,

If I were doing it today, I'd make a couple adjustments.

1. The connection from the head to the tank (shown in 
http://www.alberg30.org/maintenance/Head/RaritanNewer/PvcU-thumb.jpg) 
should have a at least 1/4" per foot slope. I end up having to pump 
extra water to clear the pipe. Don't make it too steep, though, or the 
liquids rush off and leave the solids behind.

2. The outlet connection going to the macerator and deck pumpout (shown 
in http://www.alberg30.org/maintenance/Head/RaritanNewer/PvcY-thumb.jpg) 
allows solids to build up on the lip of the pipe going to the macerator. 
I would now put the curved part of the Y going toward the macerator. 
This would mean that another 90 would be needed below it. Again, it 
would be good to ensure 1/4" per foot slope back to the tank so nothing 
builds up in the pipe.

That page was last edited in 2008, so I've been using this a long time. 
I've almost never used the macerator, though, and have had to clean hard 
chunks out of it a couple times to get it to spin.

  - George

On 12/28/17 6:07 PM, Stephen Gwyn via Public-List wrote:
> Hi everybody and George in particular,
> 
> How long has the installation described at:
> http://www.alberg30.org/maintenance/Head/RaritanNewer/4-plumbing.html
> been in operation? Any problems?
-- 
  ----------------------------------------------------------------------
   When I remember bygone days                         George Dinwiddie
   I think how evening follows morn;            gdinwiddie at alberg30.org
   So many I loved were not yet dead,           http://www.Alberg30.org
   So many I love were not yet born.                          also see:
                'The Middle' by Ogden Nash     http://idiacomputing.com
  ----------------------------------------------------------------------






More information about the Public-List mailing list