[Public-List] Teak inlay in cockpit seats and hatch cover

[Mike Lehman via Public-List]

When I did the strips, I did not do a border, just stright strips. I did
radius the corners and beveled the outer edges to the angle of the
fiberglass. I don't remember the angle, but used some scrap material until
I got the angle right.

On Feb 1, 2017 5:02 PM, "Stephen Gwyn via Public-List" <
public-list at lists.alberg30.org> wrote:

>
> Hi,
>
> My boat (Hull #495) has teak plywood inset into fibreglass for both
> the cockpit seats / locker lids and the sliding hatch. After only 45 years,
> the teak is starting to rot. The depression in the cockpit seats
> is 3/4" deep. The depression on the sliding hatch cover is 3/8" deep.
> This piece of teak has fore-and-aft cuts on the bottom side so
> the plywood can bend to meet the curve.
>
> I'd like to switch to teak battens, with black sealant in between.
>
> Has anybody done this?
>
> SG
>
>
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>