[Public-List] Public-List Digest, Vol 3559, Issue 1

Gordon Laco mainstay at csolve.net
Wed Oct 25 15:10:01 PDT 2017


Good plan.  I think I'll do it too...

Gord 
#426 Surprise 

On 2017-10-25, at 6:05 PM, Mike Lehman via Public-List <public-list at lists.alberg30.org> wrote:

> Daniel,
> 
> I had the same problem on 505. In fact, you'll see this on most liner
> boats. The shelves in the forward cabin are secondary struct Ural members.
> On the later boats, with liners, they pop riveted the shelves to tabbing
> that runs fore and aft. The shelves attached this way do not provide the
> support for the forward lowers. What I did was 1 loosen the rig, 2 push the
> hull outward using 2x4s and wedges, then fiberglass the shelves in place
> with heavy cloth. I also glasses the knees to the underside of the deck.
> This was done about 30 years ago and the dimples have never reappeared.
> 
> On Oct 24, 2017 4:27 PM, "Daniel Swords via Public-List" <
> public-list at lists.alberg30.org> wrote:
> 
>> 
>> 
>> 
>> Sent from Yahoo Mail for iPhone
>> 
>> 
>> On Tuesday, October 24, 2017, 3:06 PM, public-list-request at lists.
>> alberg30.org wrote:
>> 
>> Send Public-List mailing list submissions to
>>    public-list at lists.alberg30.org
>> 
>> To subscribe or unsubscribe via the World Wide Web, visit
>>    http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>> or, via email, send a message with subject or body 'help' to
>>    public-list-request at lists.alberg30.org
>> 
>> You can reach the person managing the list at
>>    public-list-owner at lists.alberg30.org
>> 
>> When replying, please edit your Subject line so it is more specific
>> than "Re: Contents of Public-List digest..."
>> 
>> 
>> Please do NOT include the entire digest in your reply!
>> ======================================================
>> 
>> 
>> 
>> Forward Shroud Dimples?
>> My boat, Hull #525, has dimples in the hull on both sides located at the
>> forward shroud. The shroud tension is about 700 lbs and there is no
>> evidence of any problems with the bulkhead or chain plates. I plan to
>> continue ignoring the dimples but am just curious if others also have them?
>> Daniel SwordsMandeville, LASolitude (#525)>
>>> _______________________________________________
>>> These businesses support your Association:
>>> http://www.alberg30.org/store/A30supporters.html
>>> Please support them.
>>> _______________________________________________
>>> Public-List mailing list
>>> Public-List at lists.alberg30.org
>>> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>> 
>> 
>> ------------------------------
>> 
>> Subject: Digest Footer
>> 
>> _______________________________________________
>> These businesses support your Association:
>> http://www.alberg30.org/store/A30supporters.html
>> Please support them.
>> _______________________________________________
>> Public-List mailing list
>> Public-List at lists.alberg30.org
>> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>> 
>> 
>> ------------------------------
>> 
>> End of Public-List Digest, Vol 3559, Issue 1
>> ********************************************
>> 
>> 
>> 
>> _______________________________________________
>> These businesses support your Association:
>> http://www.alberg30.org/store/A30supporters.html
>> Please support them.
>> _______________________________________________
>> Public-List mailing list
>> Public-List at lists.alberg30.org
>> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org


More information about the Public-List mailing list