[Public-List] Tomfoolery -- Alberg 35 Rigging Failure
Mike Lehman
mlehman at gmail.com
Tue Oct 31 04:57:19 PDT 2017
I install brand new cotter pins every year.
On Oct 30, 2017 9:14 PM, "Jonathan Bresler via Public-List" <
public-list at lists.alberg30.org> wrote:
> Folks,
>
> Was catching up on issues of Good Old Boat this weekend. Read about the
> rigging failure on Tomfoolery, an Alberg 35, in the September/October
> issue. A steel cotter pin, inserted into a bronze clevis pin securing the
> jib stay, corroded and in corroding increased in diameter. The cotter pin
> was a tight fit and in corroding split the clevis pin securing the jibstay
> to the stem.
>
> Got to wondering about Constance. If that was the case on an Alberg 35,
> then perhaps Alberg 30's might have the same issue. Happy to report that
> the cotter pin was not corroded and was not a tight fit in the bronze
> clevis pin. However, one of the two bent legs of the cotter pin had
> broken off. The other leg broke off immediately upon my first attempt to
> straighten it in order to replace the cotter pin. Cotter pin has been
> replaced with another, one that is just a bit small so that there is a bit
> of room between the cotter pin and the clevis pin.
>
> You may wish to check yours as well. The article starts on page 36 of the
> September/October 2017 issue of Good Old Boat.
>
> Jonathan
> --
> Jonathan M Bresler
> S/V Constance Alberg 30 #262
> Annapolis/Eastport MD
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>
More information about the Public-List
mailing list