[Public-List] Garboard drains

[Mike Lehman]

I measured the garboard drain on A30 #123 down at the marine down the
street from me. It is 12" center of hole to bottom of keel.  27" center of
hole to back of keel on a line parallel with bottom of keel. Inside it is
about 1" or less above the ballast. Hope this helps.

On Sun, Apr 21, 2019, 9:57 AM Greg Dawson via Public-List <
public-list at lists.alberg30.org> wrote:

> Hi All
> Has anyone out there fitted a garboard drain to their A30? If yes, what
> did you use to seat it. Epoxy, 5200 or 4200? The keel at the bottom of the
> bilge has a slightly concave surface. I am concerned about creating a good
> seal and seating the drain securely. Does anyone have thoughts about
> manufacturers and materials? There seem to be a few out there that produce
> the drain in bronze whilst the plug is brass. What about stainless would
> that be a reasonable choice? Your thoughts and experience would be
> appreciated.
> Sincerely.
> Greg Dawson #348
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>