[Public-List] Rivet for mast rail

[Eric Chavigny]

Thanks for the information!

Sent from my iPhone

> On Jul 29, 2019, at 00:24, Marcelo D. Gentinetta via Public-List <public-list at lists.alberg30.org> wrote:
> 
> Hi Eric,
> I just changed 3 rivets on the mast track approximately 2/3 up the mast. The rivet size in stainless is 3/16 diameter with a grip size of 0.158"-0.236”. You have to drill out the old rivet using a 13/64” bit. I used a heavy duty rivet gun with the long handles. I tried using the regular, one handed kind of rivet gun that is usually sold in most hardware stores but found I wasn’t strong enough to pop those hard SS rivets. 
> I hope this helps,
> Marcelo
> #441 Alegría
> 
>> On Jul 28, 2019, at 5:38 PM, Eric Chavigny via Public-List <public-list at lists.alberg30.org> wrote:
>> 
>> A short section of our mast rail for the main sail is slightly separate from the mast and I want to remove the rivet redo it so the rail is fully seated on the mast.
>> 
>> Anyone know the rivet size for these?
>> 
>> Thanks
>> 
>> Dimanche Matin #541
>> 
>> Sent from my iPhone
>> _______________________________________________
>> These businesses support your Association:
>> http://www.alberg30.org/store/A30supporters.html
>> Please support them.
>> _______________________________________________
>> Public-List mailing list
>> Public-List at lists.alberg30.org
>> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
> 
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org