[Public-List] Spreader/mast bracket

[Kris Coward]

For some reason, mine are always a bit of a loose fit that go on easily,
but a snug fit that need to be wiggled a bit before they come off ;)

-K

On Thu, May 02, 2019 at 06:26:01AM -0400, Greg Hounsell via Public-List wrote:
> I assume it should be a snug fit. On mine the alum tubing had electrical
> tape wrapped around the base to make it snug.
> 
> I removed that and glued a thin piece if cork inside the base (~1/32 thick)
> and that snugged it right up.
> 
> Greg
> 592
> 
> On Wed, May 1, 2019, 9:57 PM Christian Douglas via Public-List <
> public-list at lists.alberg30.org> wrote:
> 
> > May be a dumb question, but when I removed the spreaders last year, there
> > was some play in the bracket/spreader connection. Is that correct or should
> > spreaders be rigid in that bracket?
> >
> > Christian
> > Kittiwake #76
> > _______________________________________________
> > These businesses support your Association:
> > http://www.alberg30.org/store/A30supporters.html
> > Please support them.
> > _______________________________________________
> > Public-List mailing list
> > Public-List at lists.alberg30.org
> > http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
> >
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org

-- 
Kris Coward					http://unripe.melon.org/
GPG Fingerprint: 2BF3 957D 310A FEEC 4733  830E 21A4 05C7 1FEB 12B3