[Public-List] Companionway Hatch

[George Dinwiddie]

One thing that works is a hex screwdriver bit held with needle-nose vice 
grips.

  - George

On 8/11/20 12:22 PM, Richard Hansen via Public-List wrote:
> True George.  2 screws per tab, but both tabs on one side must be removed
> to slide/lift to the other side.  Not all offset screwdriver/wrench sets
> are small enough to fit under the hatch.  Believe me, I bought a few with
> great hope.  Finally found a cheap give away set from some industry
> conference that fit.  RDH

-- 
  ----------------------------------------------------------------------
   When I remember bygone days                         George Dinwiddie
   I think how evening follows morn;            gdinwiddie at alberg30.org
   So many I loved were not yet dead,           http://www.Alberg30.org
   So many I love were not yet born.                          also see:
                'The Middle' by Ogden Nash     http://idiacomputing.com
  ----------------------------------------------------------------------