[Public-List] Cockpit Coamings

Mike Meinhold meinhold272 at gmail.com
Thu Dec 3 13:31:40 PST 2020


Tom. I have done this. It depends on the residual strength of any bedding
that was used to install them .  If they are original then the bedding is
probably degraded and little prying will be required .

The nuts are not too difficult to get to, but do require getting into the
lockers.

I suggest removing all the hardware, then inserting wedges all along the
wood-Fiberglass edge.
In my case it just took a good yank to get them off .

Good luck!
Mike
Rinn Duin #272

On Thu, Dec 3, 2020 at 16:25 Tom Dodds via Public-List <
public-list at lists.alberg30.org> wrote:

> My cockpit coamings require refinishing. As it is somewhat difficult to
> refinish them in place, I am considering removing them and refinishing at
> home. Can anyone advise me of the difficulty in removing and re-installing
> them.
>
> Thanks
> Tom Dodds
> StageOne
>
> Sent from my iPad
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
>



More information about the Public-List mailing list