[Public-List] Replacing Taffrail

Don Campbell dk.campbell at xplornet.ca
Mon May 11 10:50:42 PDT 2020


If  you use "glue " on teak I suggest you consider using G-Flex epoxy, 
developed for oily woods.
Don

------ Original Message ------
From: "George Dinwiddie via Public-List" 
<public-list at lists.alberg30.org>
To: public-list at lists.alberg30.org
Cc: "George Dinwiddie" <gdinwiddie at alberg30.org>
Sent: 2020-05-11 12:24:52 PM
Subject: Re: [Public-List] Replacing Taffrail

>Richard,
>
>http://alberg30.org/maintenance/HullDeck/NewerTaffrail/ shows the process I used to replace the taffrail on Calypso, #543. My taffrail was made by Cy Fishburn, who laminated strips of teak together to give a curved shape with less waste. It's held up pretty well, and would have done better if I'd kept it varnished.
>
>  - George
>
>On 5/11/20 11:37 AM, Carla via Public-List wrote:
>>I am looking to replace the 50 year old taffrail on Quest 433, a liner boat that has the shorter Taffrail. I measure it at 3/8” but have no idea how much may have been sanded away over the years. It does however mate up relatively well where it meets the quarter cap rails.  It appears to have been originally made using three 4” wide boards glued together and cut to the radius of the raised deck molding.  So far I have been able to source 1/2” up to 6” wide.  After plaining down to 3/8” this would require only two glue joints.
>>
>>I have a friend who is builds antique furniture and has agreed to help with the woodworking. We will use the existing taffrail as a template. Other than removing the 50 year old bungs and likely rusted fasteners does anybody have any thoughts or advice regarding this work.  Also would I be advised to try and locate a 12” wide board and avoid glue joints altogether.
>>
>>Thanks, for any advice and/or suggestions for sourcing the teak lumber.
>>
>
>--  ----------------------------------------------------------------------
>   When I remember bygone days                         George Dinwiddie
>   I think how evening follows morn;            gdinwiddie at alberg30.org
>   So many I loved were not yet dead,           http://www.Alberg30.org
>   So many I love were not yet born.                          also see:
>                'The Middle' by Ogden Nash     http://idiacomputing.com
>  ----------------------------------------------------------------------
>
>
>
>_______________________________________________
>These businesses support your Association:
>http://www.alberg30.org/store/A30supporters.html
>Please support them.
>_______________________________________________
>Public-List mailing list
>Public-List at lists.alberg30.org
>http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org




More information about the Public-List mailing list