[Public-List] What finish to use on teak cockpit seats

[R Kirk]

I have known a number of people with teak decks and they either cleaned and left the teak raw(bright) or cleaned and used MoldArmour to keep them bright. I know you are not talking about decks here.  
ggOf course, the right way to clean teak decks to a lustrous finish is to use an endless supply of sailors rubbing sand & seawater across the deck, in unison & rhythm, with holystones. Repeat weekly until the teak is worn enough to replace. (USS Iowa 1956 experience)


-----Original Message-----
From: Michael Connolly via Public-List <public-list at lists.alberg30.org>
To: Alberg 30 Public List -- open to all <public-list at lists.alberg30.org>
Cc: Michael Connolly <crufone at comcast.net>; Greg Roberts <greg at midnight-oil.us>
Sent: Mon, Feb 14, 2022 10:17 pm
Subject: Re: [Public-List] What finish to use on teak cockpit seats

Greg,
I have known a number of people with teak decks and they either cleaned and left the teak raw(bright) or cleaned and used MoldArmour to keep them bright. I know you are not talking about decks here.  Steve has a point, Teak oil if used (sparingly) will saturate the teak and bring out the tone.  Too much teak oil and you end up with basically an oil finish which looses its non-skid effect. Oil finishes are much easier to care for than full blown bright varnish. Teak oil is an oil finish and will support mold growth, esp in the southern climes.  My experience is with sweet water boats.  Salt water southern climes are another story entirely.

I would strongly caution you and head in a new direction only after you have throughly investigated what is best for the climate where you normally sail. Also remember KISS = Keep it simple stupid.  Whatever you add to your teak you are adding to its maintenance = less time enjoying sailing on the water.  Personally I liked the Herreshoff design with all the teak treated with Mould Armour.  This guy was from Chicago, IL and applied the Mould Armopur once a season ....like in May and I saw his boat in late August and it looked like he had just cleaned the bright (raw) Teak.  I questioned him extensively and he had been doing this process for the past ten years with very nice results and not much labor to boot.

How often do you clean your teak?  My Dad had a CC Constellation with teak decks. He cleaned them two or three times a season.  He purchased the boat in 1967 and sold it in 1976 and the decks looked the same when he sold it as when he bought it. Again this was a Great Lakes boat. Greg what you have now.... raw Teak is the simplest for maintenance you can get.

Good luck,
Let the group know what you try and what results you get.
Michael #133
> On 02/14/2022 12:12 PM Greg Roberts via Public-List <public-list at lists.alberg30.org> wrote:
> 
>  
> Hi Folks,
> I have solid teak seats/lazarette hatches that I've left raw for
> non-skid reasons. What, if any finish have folks used that doesn't
> create a slick surface when wet? I'd like them to look better but
> safety first...
> Regards,
> Greg
> Ayla
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org
_______________________________________________
These businesses support your Association:
http://www.alberg30.org/store/A30supporters.html
Please support them.
_______________________________________________
Public-List mailing list
Public-List at lists.alberg30.org
http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org