[Public-List] more tiller-to-rudder

[Michael Connolly]

Stephen,
Yes, that is where I place bronze washers to take up the clearance.  If the holes where the bolt is are elongated then you need to drill out a slightly larger hole and use a bushing around the original bolt. If the bolt is worn, just replace the bolt.  In some cases one might have to do all three to regain the sensitive feel you like to have at the tiller.
Michael #133
> On 03/31/2024 4:53 PM EDT Stephen Gwyn via Public-List <public-list at lists.alberg30.org> wrote:
> 
>  
> Maybe we are talking about different areas being loose. I was putting
> washers in the hinge as it were, between the H-shaped part attached to the
> tiller and the fitting on the top of the rudder post, threaded onto the
> bolt on which the tiller pivots up and down.
> 
> SG
> _______________________________________________
> These businesses support your Association:
> http://www.alberg30.org/store/A30supporters.html
> Please support them.
> _______________________________________________
> Public-List mailing list
> Public-List at lists.alberg30.org
> http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org