[Public-List] Public-List Digest, Vol 4515, Issue 1

[Pier-André Bouchard St-Amant]

Hi Greg,
 I hope you are well.

It is a Fairview ball valve made of full brass and with a stainless steel lever. It is part 7558200 in this catalogue:

https://www.maritimemarinesupply.ca/catalogue-plumbing/

My exhaust line is 2", so the part number match this size, but other sizes are available. 

It needs to be complemented with two nipples so as to fit within the rubber line.

I'm not sure of the rated temperature. Brass melts at 1710°F (919°C). Half this figure is well above the rubber melting point (180°C), so I do not see how the valve can be the failure point if there is overheating. Do you have a case in mind?

I hope this helps.

Best,

Pier, #399 









Le 24 juin 2024 17 h 23 min 02 s HAE, Greg via Public-List <public-list at lists.alberg30.org> a écrit :
>Hi Pier,It looks like you have a ball valve to seal your exhaust line. I'm considering adding one. What did you use? What temperature is it rated for?Regards,GregAyla
>_______________________________________________
>These businesses support your Association:
>http://www.alberg30.org/store/A30supporters.html
>Please support them.
>_______________________________________________
>Public-List mailing list
>Public-List at lists.alberg30.org
>http://lists.alberg30.org/listinfo.cgi/public-list-alberg30.org