<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META content="text/html; charset=iso-8859-1" http-equiv=Content-Type>
<META content="MSHTML 5.00.2314.1000" name=GENERATOR>
<STYLE></STYLE>
</HEAD>
<BODY bgColor=#ffffff>
<DIV><FONT size=2>Boy, am I learning a lesson. I finished the port side of
"Zevulun" with Iterlux Brightsides. I put two coats of primer as directed
by the factory using brush strokes horizontal for the first coat and vertical
for the second coat. I called the factory again because the brush strokes
were so apparent. They told me not to worry, it would look OK. It
looks terrible. After one coat of final paint, you can still see awful
brush strokes. I believe the problem is the primer. On the starboard
side I tried a small patch with no primer and it looks a lot better. I'm
am going to do the starboard side with no primer. After waiting a few days
to let the port side cure, I'm going to sand it down and start over again.
Live and learn. I don't blame the paint or the advise I got from the
factory. They couldn't see my results. I think it may have been a
bit too warm or humid (it was upper 70's) when I put the primer on and I didn't
use thinner. If anyone else had a similar problem, I would like to hear
about it to see if there is something else I could have done, or could
do.</FONT></DIV>
<DIV> </DIV>
<DIV><FONT size=2>John Bailey</FONT></DIV>
<DIV><FONT size=2>"Zevulun" #33</FONT></DIV>
<DIV> <SPAN id=__#Ath#SignaturePos__></SPAN> </DIV>
<!-- |**|begin egp html banner|**| -->
<hr>
<!-- |@|begin eGroups banner|@| runid: 4831 crid: 2067 -->
<a target="_blank" href="http://click.egroups.com/1/4831/10/_/476031/_/966769471/"><center>
<img width="468" height="60"
border="0"
alt="Click Here!"
src="http://adimg.egroups.com/img/4831/10/_/476031/_/966769471/"></center><center><font color="black"></font></center></a>
<!-- |@|end eGroups banner|@| -->
<hr>
<!-- |**|end egp html banner|**| -->
</BODY></HTML>