[alberg30] re holding tank

[Tom Sutherland]

From: Tom Sutherland <tomsu at uky.campuscw.net>

I for one would be interested in seeing your photos. Also, what would you
estimate the capacity of this arrangement be ?

Tom S
A30 #412

Mpete53 at aol.com wrote:

> From: Mpete53 at aol.com
>
> Like Bob Lincoln instillation, I used the forward compartment under the cabin
> sole for my holding tank.
> My compartment is part of the inner hull liner, not the hull. The liner had
> two flats already molded in, one for the floor board, and the second one
> about 3/8 of a inch lower. I made a fiberglass top and fiberglass tubes that
> were glassed into the top for my inlets and outlets. I then glued the whole
> top on using 3M 5200. So far the system has held up well.
>
> Will post or e-mail photos of project if the group is interested.




--------------------------- ONElist Sponsor ----------------------------

ONElist:  your connection to like-minds and kindred spirits.

------------------------------------------------------------------------

 936031823.0