[alberg30] masthead

Gord Laco gord at transatmarine.com
Fri Dec 29 10:21:07 PST 2000


HELLO,

The nicro press top ends on shrouds and stays is the original way Whitby did
it... and yes, the other options are all better.

Gord KC426 Surprise

----- Original Message -----
From: Bob Johns <rjohns3 at optonline.net>
To: <alberg30 at egroups.com>
Sent: Friday, December 29, 2000 8:46 AM
Subject: Re: [alberg30] masthead


> >I would like to see a good resolution closeup photograph of the masthead
> >and masthead rigging connections of an A30.Is there a site with one,or
> >does anyone have one they could e-mail? I looked at my own recently
> >through binoculars. The upper shrouds were run through holes in tangs
> >attached to the mast, folded over and clamped with Nicopress fittings.
The
> >backstay was folded over a bolt through the masthead fitting and again
> >clamped to itself with a Nicopress.I'm no expert on rigging but this
seems
> >unusual.
> >The lowers were connected to their tangs with swaged forks which is more
> >conventional.
> >Peter Amos
>
> Peter,
>
> All of my rigging uses swaged forks - no Nicopress - what you have is
> unusual. Folding over  the shrouds and backstay  is a bad idea. The
> normally installed rigging wire (1x19 ?) is not meant to be bent sharply.
> The stainless steel wire used used for halyards still should not be bent
> that sharply. i would change it to the arrangement on the lowers.
>
> Bob Johns, Wind Call #397
>
>
>
>
>
>


-------------------------- eGroups Sponsor -------------------------~-~>
Big News - eGroups is becoming Yahoo! Groups
Click here for more details:
http://click.egroups.com/1/10801/1/_/476031/_/978116052/
---------------------------------------------------------------------_->



 978114067.0


More information about the Public-List mailing list