[Alberg30] Interior moulding

[Mike Lehman]

I am pretty sure that it is not original. This is a common location for a transducer. Does it have a thru-hull fitting with a valve mounted on it, or is it just plugged? I have one in about the same location that was added for a speedometer which I never use any longer since the GPS. Rather than glass over the hole, I plan to convert it for use as an intake for a bow wash-down.
  ----- Original Message ----- 
  From: Peter Amos 
  To: public-list at alberg30.org 
  Sent: Tuesday, December 31, 2002 2:37 PM
  Subject: [Alberg30] Interior moulding


  Tait Tait #478 has a small GRP moulding in the cabin on the hull where it rises from the cabin sole.It is about three feet aft of the V berth bulkhead on the starboard side.It is roughly six inches wide six inches high at its deepest side,has a horizontal top with a circular hole about two inches in diameter cut in the top.I think it may be for a depthfinder transducer but am not really sure.It also looks original,not an add on.Anyone else have one of these? Happy New Year everyone.
  Peter Amos
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.alberg30.org/pipermail/public-list-alberg30.org/attachments/20021231/c1681eba/attachment-0008.htm>