[Public-list] Chainplate covers?

[sousa, stephen (ENG)]

Don,

If you could share the method used for the pattern it would be appreciated.
This may be one of those items that would fall into the group purchase area.
It would benefit all Alberg owners and could be very inexpensive it we
purchase a large quantity. I would expect that all boats have the same
installation for chainplates, so one pattern could be used on all boats? 

Thanks,
Stephen
 

-----Original Message-----
From: public-list-bounces at alberg30.org
[mailto:public-list-bounces at alberg30.org] On Behalf Of Don Campbell
Sent: Sunday, December 12, 2004 7:48 PM
To: Alberg 30 Public List -- open to all
Subject: Re: [Public-list] Chainplate covers?

Randy
    When I bought #528, I was taken to see a C & C deck which had a raised
flat area around the chainplates with the SS plates of which you speak. I
knew I needed to redo the deck on this boat so incorporated a raised flat
area at the chainplates on my new deck. I then went to the scrap yard and
found some 1/8th stainless plate that was food grade so probably 316 (which
is probaly not what is best for a marine environement, 304 is stronger and
more durable,  I gather, but strength is not that important here), cut it to
size- about 1 1/2" x 2 1/2" and then took it to a machine shop to have the
slot cut.  I needed to file the edges a bit to get the chainplate angle
correct in the slot but SS is relatively soft, so not difficult once in a
vise. I have drilled 2 holes in the plates and drilled and tapped the epoxy,
raised flat areas to match so I just tighten the 2 - 1/4 x 1/2 ss machine
bolts to seal the caulking. Total cost about $25 Canadian when I did it 8
years ago -$20 of that  for the machinist. I need to redo that caulking job
this winter. The raised part of the deck decreased the torque and twist on
the chainpates at the deck level too. If you want to know how I did the
pattern for the raised flat area let me know.
Don

Randy Katz wrote:

> Speaking of chainplates (nice photos of the reinforcement straps, BTW)
> has anyone found a source for chainplate covers? They are the oval SS
> plates 2-2.5 inches long, slot in the middle, that fit over the
> chainplate straps where they stick out of the deck. They get caulked and
> sit over the deck opening, with the chain plate strap coming up through
> their middle, and serve to help seal that deck opening.
> I've checked West Marine and a few other stores-- they seem hard to find
> at all but ones the size we need I never did come across.
> Anyone know where to get them?
>
> Many Thanks,
> Randy Katz
> #249
> Seattle, WA.
>
> _______________________________________________
> Public-list mailing list
> Public-list at alberg30.org
> http://alberg30.org/mailman/listinfo/public-list

_______________________________________________
Public-list mailing list
Public-list at alberg30.org
http://alberg30.org/mailman/listinfo/public-list

 1102941999.0